Amatis Controls

The DCDIM can be installed to operate in two different modes:

As a 0-10V dimmer for fixtures powered by a 0-10V controlled driver.

As a constant voltage dimmer conforming to the wiring images below.

1. As a 0-10V dimmer for fixtures powered by a 0-10V controlled driver.
2. As a constant voltage dimmer conforming to the wiring images below.

<b>NOTE:</b> Connecting the wires when the device is right side up will assist in connecting the wire to the terminal blocks.

DCDIM

Find answers and get help from Intercom Support and Community Experts

Track the progress of all tickets related to your company.

{assigneeName} needs more information from you

MODE 1	MODE 2
CAUTION: Do not connect 24V power to terminals 5 and 6. CAUTION: Do not connect anything to terminals 3 and 4. Replace protective terminal enclosure. Mount the DCDIM using the tabs at the top and bottom of the unit. Confirm blue LED on the device is lit, indicating power. Test if the wiring is correct with black button on the device. This will turn lightly on, or fully off.	CAUTION: Do not connect anything to terminals 5 and 6. Replace protective terminal enclosure. Mount the switch using the tabs at the top and bottom of the unit. Confirm the blue LED on the device is lit, indicating power. To test if the wiring is correct, use the black button on the device. This will turn lightly on, or fully off.