The DCDIM can be installed to operate in two different modes:
- As a 0-10V dimmer for fixtures powered by a 0-10V controlled driver.
- As a constant voltage dimmer conforming to the wiring images below.

NOTE: Connecting the wires when the device is right side up will assist in connecting the wire to the terminal blocks.
MODE 1
|
MODE 2
|
- Unscrew and remove protective terminal enclosure.
- Wire 24DC power to terminals 1 and 2.
- Connect + 0-10V wire to terminal 5.
- Connect - 0-10V wire to terminal 6 (AC fixtures only; not on DC fixtures).
- CAUTION: Do not connect 24V power to terminals 5 and 6.
- CAUTION: Do not connect anything to terminals 3 and 4.
- Replace protective terminal enclosure.
- Mount the DCDIM using the tabs at the top and bottom of the unit.
- Confirm blue LED on the device is lit, indicating power.
- Test if the wiring is correct with black button on the device. This will turn lightly on, or fully off.
|
- Unscrew and remove protective terminal enclosure.
- Wire 24DC power to terminals 1 and 2.
- Wire - 24V output to terminal 3.
- Wire + 24V output to terminal 4.
- Connect 24 output to fixture with correct polarity.
- CAUTION: Do not connect anything to terminals 5 and 6.
- Replace protective terminal enclosure.
- Mount the switch using the tabs at the top and bottom of the unit.
- Confirm the blue LED on the device is lit, indicating power.
- To test if the wiring is correct, use the black button on the device. This will turn lightly on, or fully off.
|
0 Comments