Blade Troubleshooting Guide

Step 1:

Add the blade to your local area network.

Step 2:

Find blades ip address. There are several ways to do this:

  1. try https://nch300XXXX.local/ (where the serial number xxxx can be found the blade) if this fails consider installing avahi. Adarifruit can help https://learn.adafruit.com/bonjour-zeroconf-networking-for-windows-and-linux
  2. most routers will show a list of attached devices, you can find blades IP address there.
  3. use a network scanning tool like nmap or https://angryip.org/

Step 3:

Once the address of the blade has been discovered using a web browser to configure the device, https://[device ip] or https://nch300XXXX.local/ You will see a security warning, it’s expected, and means that the devices certificate can not be verified against the dynamic address above. The content is still encrypted.

mceclip0.png

Warning: Blade User interface is still in development, the user interface is slow, some options are not implemented, and some settings may take more than one try.  Rest assured while the user interface is not ready the hardware is!

Step 4:

Enter the default password npsadmin and unlock (slow, wait for it!).

mceclip1.png

Step 5:

Select “ Set Voltages “ in the left window menu.

mceclip2.png

Step 6: 

Set the desired voltage in mV (ie 14.12 volts is written as 1400 ) and “submit”.

Step 7:

Confirm the desired voltage with a meter and redo step X if the target is not attained.

mceclip3.png

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.

Contact Us