LUUM.IO
XPD-T2P-P - DATA SHEET#
Product Overview#
The X-PoE powered device serves as an intermediary between the X-PoE port and the connected LED lights or other devices, enabling power transmission and providing support for high power outputs. The PD takes the RJ45 connection from an X-PoE port and converts it to two separate channels, each with a pair of positive (+) and negative (-) conductors. These channels are used for powering LEDs or other compatible devices. The PD is capable of providing a total power output of up to 120W1.
Confirm PD Configuration
The PDs can be utilized in both generic and customized configurations, tailored to accommodate specific load types. It is crucial to verify and install the appropriate PD before establishing a connection with an X-PoE lighting controller.
Specifications#
XPD-T2P-P SPECIFICATIONS | |
---|---|
Dimensions | 56.3 mm x 28 mm x 28 mm (2.2 in x 1.1 in x 1.1 in) *Not including wires |
Panel Cut-Out | 22.2 mm (0.875 in) |
Weight | 0.01 kg (0.02 lbs) |
Interfaces | (1) RJ45 X-PoE Input Port (1) X-PoE Lighting LED Connector 2 |
Power Input | 48VDC to 57VDC Input From X-PoE Port3 |
Maximum Power Consumption | 120W (at 57VDC) With Both Channels Fully Loaded At 100%4 |
Environment | Operating Temp: 0°C to +40°C (32 to 104°F) Storage Temp: -20 to +40°C (-4 to +158°F) IP 68 Waterproof Rating |
Certifications | UL 769 & 1007, X-PoE, IP67 (when used with cap) |
Warranty | 5 Years |
Maximum Power Output
Maximum output power is dependant upon the input voltage and the forward voltage of the connected light engine.
Top Panel#
The XPD-T2P-P top panel is shown below:
- X-PoE Power Input
- Panel Nut
- Gasket
- X-PoE Output Connector
X-PoE Output Connector
This PD must be used with a Level 3 integrated fixture.
-
Maximum 120W per port with a 57V input, see D1.2 - Output Power Range. ↩
-
Connector has 2 channels, 60W per channel when used with a 57V input. ↩
-
PD must be powered by an X-PoE lighting controller. ↩
-
X-PoE port must be configured properly. ↩